Product added to your wish list! View wish list
Sign in to see your saved products on any device
Product removed from your wish list! View wish list
Sign in to see your saved products on any device
Something went wrong. Please try again later.
Product is added to compare already. Please refresh the page.
Product is not found in compare. Please refresh the page.
5 Products already added. Please delete existing selection to add this.
Share this product
Cladco 200mm x 200mm Black 90º Corner Barge Flashings in PVC Plastisol Finish - 3m
This product ad may change over time
ShareCladco 200mm x 200mm Black 90º Corner Barge Flashings in PVC Plastisol Finish - 3m
Roof Barge boards, sometimes known as Verges, are used at the end of a run of sheets to trim and seal off the edge of the roof. All roof barge flashings are a vital part of any profiled clad roof; they not only help to weatherproof the building but also add to it aesthetically too. Roof Barge Boards are available in a range of finishes and colours to match or …
Roof Barge boards, sometimes known as Verges, are used at the end of a run of sheets to trim and seal off the edge of the roof. All roof barge flashings are a vital part of any profiled clad roof; they not only help to weatherproof the building but also add to it aesthetically too. Roof Barge Boards are available in a range of finishes and colours to match or contrast our roofing sheets, depending on the look you are after. They are secured by stitching them (using st22 stitching screws) to the roofing sheet below. You will need to allow an overlap of a minimum 100mm when fitting roof barge boards end on end.
Description
Roof Barge boards, sometimes known as Verges, are used at the end of a run of sheets to trim and seal off the edge of the roof. All roof barge flashings are a vital part of any profiled clad roof; they not only help to weatherproof the building but also add to it aesthetically too. Roof Barge Boards are available in a range of finishes and colours to match or contrast our roofing sheets, depending on the look you are after. They are secured by stitching them (using st22 stitching screws) to the roofing sheet below. You will need to allow an overlap of a minimum 100mm when fitting roof barge boards end on end.
Feedback